0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
CK 9V gas-cooled 125 amp ACHF or DCSP @ 100% 20.3cm (8"), 78gm, 2 series head accessories.
Lightest most flexible cable assemblies available.
Available for all gas-cooled or water-cooled torches.
Lightweight silicon rubber hose with nylon over braid protection to resist abrasion.
Replaces heavy, stiff cables increasing range of motion.
Stays flexible even in the coldest environments.
Great for intricate precise welding applications.
For parts for this torch, click here.
Answers to common questions about choosing and using a complete light-duty, air-cooled TIG torch package.
A valve on the torch handle lets you switch the shielding gas on and off at the torch. It is most useful if your welding machine has no built-in gas solenoid to control the gas for you, and it can also be handy for checking flow or purging the hose.If your machine already controls the gas, a torch without a valve works perfectly well and is simpler. Check your machine's manual to see how gas is controlled before you choose. Our team can help you pick the right arrangement.
The HSE says the welder is responsible for daily equipment checks and for reporting defects, and that the insulation on cables, plugs and the torch should be undamaged. Look along the whole cable for cuts, crushed or kinked sections and signs of heat, and check the handle, switch and connectors for damage.Also check the torch head is assembled correctly and the gas connection is tight. If you doubt the equipment is safe, stop using it and have a competent person check or repair it before it is used again.
Yes. Argon is heavier than air and in still conditions can collect in low-lying areas, pits and enclosed spaces. The HSE warns that an atmosphere without enough oxygen can cause loss of consciousness in seconds, often without any breathlessness as a warning, and that several workers have been affected because rescuers were overcome as well.Avoid welding with shielding gas in confined spaces where you can. Where it cannot be avoided, follow your risk assessment, which should include oxygen testing, a safe system of work and emergency arrangements that do not rely on someone entering unprotected.
Most TIG arcs are started with high frequency, which produces very short sparks of several thousand volts so the arc jumps the gap without the tungsten touching the metal. This keeps the electrode clean and the start reliable.High frequency can cause interference with nearby electronic equipment, so keep the torch cable and work lead tidy and away from sensitive devices. People with medical implants such as pacemakers should take advice from their doctor and the equipment maker before working near TIG equipment. Never use a torch or cable with damaged insulation, because of the risk of electric shock; stop work and have it repaired or replaced by a competent person.
